STM32F103 uart3的RXD引脚一直为高电平，强制拉低后可进入串口接收中断

gangyijiawei · 发表于 2016-3-8 16:33:04

STM32F103 uart3的RXD引脚在配置完引脚后为浮动模式（蓝色部分），一旦进入使能串口（红色部分）就会持续为高，强制拉低后可进入串口接收中断，但是强制拉低是测试电流为50ma。
以下为初始化代码，请大家帮忙看看，这个问题困惑我一个星期了。
void uart3_init ()
{
GPIO_InitTypeDef GPIO_InitStructure;
USART_InitTypeDef USART_InitStructure;
NVIC_InitTypeDef NVIC_InitStructure;

//?????RCC??
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOB , ENABLE); //??UART3??GPIOB???
RCC_APB1PeriphClockCmd(RCC_APB1Periph_USART3, ENABLE);

//?????GPIO???
// Configure USART2 Rx (PB.11) as input floating
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_11;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_IN_FLOATING;
GPIO_Init(GPIOB, &GPIO_InitStructure);

// Configure USART2 Tx (PB.10) as alternate function push-pull
GPIO_InitStructure.GPIO_Pin = GPIO_Pin_10;
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP;
GPIO_Init(GPIOB, &GPIO_InitStructure);

//????
USART_InitStructure.USART_BaudRate = 9600;
USART_InitStructure.USART_WordLength = USART_WordLength_9b;
USART_InitStructure.USART_StopBits = USART_StopBits_1;
USART_InitStructure.USART_Parity = USART_Parity_Even;
USART_InitStructure.USART_HardwareFlowControl = USART_HardwareFlowControl_None;
USART_InitStructure.USART_Mode = USART_Mode_Rx | USART_Mode_Tx;

// Configure USART3
USART_Init(USART3, &USART_InitStructure);//????3

// Enable USART1 Receive interrupts ????????
USART_ITConfig(USART3, USART_IT_RXNE, ENABLE);
//??????????????
//USART_ITConfig(USART2, USART_IT_TXE, ENABLE);

// Enable the USART3
USART_Cmd(USART3, ENABLE);//????3

//??????
//Configure the NVIC Preemption Priority Bits
NVIC_PriorityGroupConfig(NVIC_PriorityGroup_0);

// Enable the USART3 Interrupt
NVIC_InitStructure.NVIC_IRQChannel = USART3_IRQn;
NVIC_InitStructure.NVIC_IRQChannelSubPriority = 0;
NVIC_InitStructure.NVIC_IRQChannelCmd = ENABLE;
NVIC_Init(&NVIC_InitStructure);
}