我用定时器2通道3输出PWM，然后用杜邦线将PA2与PB5连起来灯怎么不亮

liuxiangyong · 发表于 2015-11-4 20:37:48

void TIM2_PWM_Init(u16 arr,u16 psc)
{
GPIO_InitTypeDef GPIO_InitStructure;
TIM_TimeBaseInitTypeDef TIM_TimeBaseInitStructure;
TIM_OCInitTypeDef TIM_OCInitStructure;

RCC_APB1PeriphClockCmd(RCC_APB1Periph_TIM2, ENABLE);
RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);
RCC_APB2PeriphClockCmd(RCC_APB2Periph_AFIO,ENABLE);

TIM_TimeBaseInitStructure.TIM_CounterMode=TIM_CounterMode_Up;
TIM_TimeBaseInitStructure.TIM_Prescaler=psc;
TIM_TimeBaseInitStructure.TIM_Period= arr;
TIM_TimeBaseInitStructure.TIM_ClockDivision=TIM_CKD_DIV1;
TIM_TimeBaseInit(TIM2, &TIM_TimeBaseInitStructure);

GPIO_InitStructure.GPIO_Pin = GPIO_Pin_2;
GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; //
GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; //IO口速度为50MHz
GPIO_Init(GPIOA, &GPIO_InitStructure); //根据设定参数初始化GPIOB.5
//GPIO_SetBits(GPIOA,GPIO_Pin_2);

TIM_OCInitStructure.TIM_OCMode=TIM_OCMode_PWM2;
TIM_OCInitStructure.TIM_OutputState=TIM_OutputState_Enable;
TIM_OCInitStructure.TIM_OCPolarity=TIM_OCPolarity_High;
TIM_OC3Init(TIM2,&TIM_OCInitStructure);

//GPIO_PinRemapConfig(GPIO_PartialRemap_TIM3,ENABLE);
TIM_OC3PreloadConfig(TIM2,TIM_OCPreload_Enable);

TIM_Cmd(TIM2,ENABLE);

}

#include "led.h"
#include "delay.h"
#include "key.h"
#include "sys.h"
#include "usart.h"
#include "timer.h"
//ALIENTEK战舰STM32开发板实验8
//定时器中断实验
//技术支持：www.openedv.com
//广州市星翼电子科技有限公司

int main(void)
{
u16 t1=0;
u8 d=1;
delay_init(); //延时函数初始化
NVIC_Configuration(); //设置NVIC中断分组2:2位抢占优先级，2位响应优先级
uart_init(9600); //串口初始化为9600
LED_Init(); //LED端口初始化
//TIM3_Int_Init(4999,7199);//10Khz的计数频率，计数到5000为500ms
TIM2_PWM_Init(499,0);
while(1)
{
delay_ms(10);
if(d==1)t1++;
else t1--;

if(t1>300)d=0;
if(t1==0)d=1;

TIM_SetCompare3(TIM2,t1);
}
}