....烧写固件无法加载设备树...

borrow1988

....烧写系统提示：
U-Boot 2016.03 (Dec 27 2022 - 16:54:58 +0800)

CPU:   Freescale i.MX6ULL rev1.1 69 MHz (running at 396 MHz)
CPU:   Industrial temperature grade (-40C to 105C) at 47C
Reset cause: POR
Board: MX6ULL_BORROW_EMMC
I2C:   ready
DRAM:  512 MiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
*** Warning - bad CRC, using default environment

Display: TFT43AB (480x272)
Video: 480x272x24
In:    serial
Out:   serial
Err:   serial
switch to partitions #0, OK
mmc1(part 0) is current device
Net:   FEC1
Error: FEC1 address not set.

Normal Boot
Hit any key to stop autoboot:  0
syntax error
switch to partitions #0, OK
mmc1(part 0) is current device
switch to partitions #0, OK
mmc1(part 0) is current device
reading boot.scr
** Unable to read file boot.scr **
reading zImage
5612496 bytes read in 137 ms (39.1 MiB/s)
Booting from mmc ...
reading imx6ull-alientek-emmc.dtb
** Unable to read file imx6ull-alientek-emmc.dtb **
Kernel image @ 0x80800000 [ 0x000000 - 0x55a3d0 ]

Starting kernel ...


找不到imx6ull-alientek-emmc.dtb

查看uboot的EMMC
Hit any key to stop autoboot:  0
=> ls mmc 1:1
  5612496   zimage
    39459   imx6ull-14x14-evk.dtb

2 file(s), 0 dir(s)

=>
  5612496   zimage
    39459   imx6ull-14x14-evk.dtb

2 file(s), 0 dir(s)

=>


怎么解决？...

起个什么名字好

** Unable to read file imx6ull-alientek-emmc.dtb **，你的设备树是imx6ull-14x14-evk.dtb，名字对不上。最直接的方法就是把你设备树名字改为imx6ull-alientek-emmc.dtb