求帮忙，下不进去程序了，Programming Failed!，之前下过程序好使的

雁过不留痕8

JLink info:

------------

DLL: V4.15n, compiled Jun 18 2010 19:55:09

Firmware: J-Link ARM V8 compiled May 20 2010 17:07:46

Hardware: V8.00

S/N : 17892859 

Feature(s) : RDI,FlashDL,FlashBP,JFlash 

 

* JLink Info: TotalIRLen = 9, IRPrint = 0x0011

* JLink Info: Found Cortex-M3 r1p1, Little endian.

* JLink Info: TPIU fitted.

* JLink Info:   FPUnit: 6 code (BP) slots and 2 literal slots

**JLink Warning: Could not set S_RESET_ST

ROMTableAddr = 0xE00FF003

 

Target info:

------------

Device: STM32F103VB

VTarget = 3.293V

State of Pins: 

TCK: 1, TDI: 0, TDO: 1, TMS: 0, TRES: 1, TRST: 1

* JLink Info: TotalIRLen = 9, IRPrint = 0x0011

* JLink Info: Found Cortex-M3 r1p1, Little endian.

* JLink Info: TPIU fitted.

* JLink Info:   FPUnit: 6 code (BP) slots and 2 literal slots

Hardware-Breakpoints: 6

Software-Breakpoints: 2048

Watchpoints:          4

JTAG speed: 2000 kHz

 

* JLink Info: Core is locked-up!

* JLink Info: CPU halted

Erase Done.

Programming Failed!
之前下载过程好使的，但是今天下载就出现问题了，而且只有Programming Failed!，求大家帮忙

ST-FAE-SALE

你clean target之后，看看。再重新编译。

Dayfly

楼主解决了没  我自己焊的10块板子小板子  开始能下的  后来我用酒精清洗了一下松香  就有两块出现现在这个状况了