OpenEdv-开源电子网

 找回密码
 立即注册
正点原子全套STM32/Linux/FPGA开发资料,上千讲STM32视频教程免费下载...
查看: 4415|回复: 5

几颗ic,看看大家有用到不?非常实惠,属于公司库存货,全新原装2010+

[复制链接]

26

主题

279

帖子

0

精华

中级会员

Rank: 3Rank: 3

积分
409
金钱
409
注册时间
2010-12-15
在线时间
0 小时
发表于 2012-2-21 14:23:01 | 显示全部楼层 |阅读模式
 先上连接
1.WINBON SDRAM http://item.taobao.com/item.htm?id=13895198704
2.REALTEK 4口以太网控制器 http://item.taobao.com/item.htm?id=15702144918

1. GENERAL DESCRIPTION
W9816G6CH is a high-speed synchronous dynamic random access memory (SDRAM), organized as
512K words × 2 banks × 16 bits. Using pipelined architecture and 0.13 μm process technology,
W9816G6CH delivers a data bandwidth of up to 400M bytes per second (-5). For different applications
the W9816G6CH is sorted into the following speed grades: -5, -6, -7. The -5 parts can run up to
200Mhz/CL3. The -6 parts can run up to 166Mhz/CL3. The -7 parts can run up to 143Mhz/CL3. For
handheld device application.
Accesses to the SDRAM are burst oriented. Consecutive memory location in one page can be
accessed at a burst length of 1, 2, 4, 8 or full page when a bank and row is selected by an ACTIVE
command. Column addresses are automatically generated by the SDRAM internal counter in burst
operation. Random column read is also possible by providing its address at each clock cycle. The
multiple bank nature enables interleaving among internal banks to hide the precharging time.
By having a programmable Mode Register, the system can change burst length, latency cycle,
interleave or sequential burst to maximize its performance. W9816G6CH is ideal for main memory in
high performance applications.
2. FEATURES
y 3.3 /3.3 +/- 10% power supply
y 524,288 words x 2 banks x 16 bits organization
y CAS latency: 2 and 3
y Burst Length: 1, 2, 4, 8, and full page
y Burst read, Single Write Mode
y Byte data controlled by UDQM and LDQM
y Auto-precharge and controlled precharge
y 4K refresh cycles/64 mS
y Interface: LVTTL
y Packaged in 50-pin, 400 mil TSOP II, using PB free with RoHS compliant.

/////////////////////////////////////////////////////////////////////////////////
RTL8304E   
     
  
  
  
  
Single-Chip 4-Port 10/100Mbps Ethernet Switch Controller with Dual MII/RMII Interfaces  
   
General Description  
The RTL8304E-CG is a 4-port Fast Ethernet switch controller that integrates memory, four MACs, and two physical layer transceivers for 10Base-T and 100Base-TX operation into a single chip.

  

The RTL8304E supports two MII/RMII interface for external devices to connect to the 3rd and 4th MACs. The external device could be a routing engine, HomePNA, HomePlug, or another processor depending on the application.  

  

The RTL8304E supports several advanced QoS functions with four-level priority queues to improve multimedia or real-time networking applications, including:

Multi-priority assignment
Differential queue weight
Port-based and queue-based rate limitation
16-entry ACL for advanced packet control application
  

For multicast applications, the RTL8304E supports IGMPv1/v2/v3 and MLDv1/v2 snooping.

  

To meet security and management requirements, the RTL8304E supports IEEE 802.1x Port-based/MAC-based Access Control, MAC Address Limits, Port Isolation, Port Mirroring, and also supports five 32-bit MIB Counters on each port.

  

The RTL8304E supports 16 VLAN groups. These can be configured as port-based VLANs and/or 802.1Q tag-based VLANs. The RTL8304E also supports VLAN translation and QinQ.

  

The RTL8304E contains a 2K-entry address lookup table. Two 4-way associative hash algorithms avoid hash collisions and maintain forwarding performance. The 2K-entry table provides read/write access from the SMI interface, and each of the entries can be configured as a static entry that does not automatically age out and can only be controlled by the external management processor. For IGMP/MLD snooping application, each of the 2K entries can be configured as a multicast entry that indicates the matched packets will be forwarded to specific multi ports. For IEEE 802.1x application, each of the 2K entries can be configured as an authorized or unauthorized entry.

Maximum packet length can be 2047 bytes. Two types of independent storm filter are provided to filter packet storms, and an intelligent switch engine prevents Head-of-Line blocking problems. The filtering function is supported for IEEE 802.1D specified reserved multicast addresses (01-80-C2-00-00-02 and 01-80-C2-00-00-04 to 01-80-C2-00-00-0F).

  

The RTL8304E provides flexible LED functions for diagnostics. An externally managed processor can control the LEDs via SMI.

  

The RTL8304E supports Realtek’s Green Ethernet power saving mode, as well as Energy-Efficient Ethernet mode (EEE; defined in IEEE 802.3az) to minimize system power consumption. When the Green Ethernet Feature is enabled, the RTL8304E provides link-on and dynamic detection of cable length and dynamic adjustment of power required for the detected cable length. This feature provides high performance with minimum power consumption.

  

Energy-Efficient Ethernet (EEE) supports Low Power Idle Mode. When Low Power Idle Mode is enabled, systems on both sides of the link can disable portions of the functionality and save power during periods of low link utilization.

  

For whole system power saving, the RTL8304E supports the Wake-on-LAN (WOL) function and provides control signals to manage the system power based on the port linkage and the traffic loading of the CPU port.

  

To simplify the peripheral power circuit, the RTL8304E can use a low-cost PNP transistor to generate 1.8V from a 3.3V power supply.

  
  
   
Features  
Basic Switching Functions
4-port switch controller with 2 transceivers for 10Base-T and 100Base-TX and 2-port (T)MII/RMII
Non-blocking wire-speed reception and transmission and non-head-of-line-blocking forwarding
Complies with IEEE 802.3/802.3u auto-negotiation
Built-in high efficiency SRAM for packet buffer, with 2K-entry lookup table and two 4-way associative hash algorithms
2047 byte maximum packet length
Flow control fully supported:
Half duplex: Back pressure flow control
Full duplex: IEEE 802.3x flow control


Service Quality
Supports high performance QoS function on each port:
Supports 4-level priority queues
Weighted round robin service
Supports strict priority
Input/Output port bandwidth control
Queue based bandwidth control
ACL-based, 1Q-based, Port-based, DSCP-based, VID-based, IP address-based, and other types of priority assignments
Supports 16-entry ACL for advanced applications
Supports IEEE 802.1p Traffic Re-marking
Supports IGMP v1/v2/v3 and MLD v1/v2 snooping


Security and Management
Supports MAC Limit
Supports Port Isolation
Supports IEEE 802.1x
Lookup Table is accessible via SMI
Supports 32-bit smart counter for per port RX/TX byte/packet count, collision counter, and error counter
Supports reserved control frame filtering
Supports advanced storm filtering
Supports Port Mirroring
Supports interrupt for CPU application
Supports proprietary CPU tag for traffic management
Supports SMI (Serial Management Interface) for programming and diagnostics
Optional EEPROM interface for configuration
VLAN Functions
Supports up to 16 VLAN groups
Flexible 802.1Q port/tag-based VLAN
Supports VLAN translation
Supports QinQ
Leaky VLAN for ARP/unicast/IP multicast packets
Supports external processor to maintain greater than 16 VLAN groups


Power Saving Functions
Green Ethernet Feature
Supports Energy-Efficient Ethernet (EEE) function (IEEE 802.3az)
Supports Wake-on-LAN (WOL)
Supports system power management based on link and CPU port traffic loading


Diagnostic Functions
Supports IEEE 802.1D
Supports hardware loop detection function with LEDs and buzzer to indicate the existence of a loop
Supports cable diagnosis (RTCT function)
Supports MAC and PHY loopback function for diagnosis
Flexible LED indicators for link, activity, speed, as well as user defined LED output
Loop status indication
LEDs blink upon reset for LED diagnostics


Other Features
Optional MDI/MDIX auto crossover for plug-and-play
Physical layer port Polarity Detection and Correction function
Robust baseline wander correction for improved 100Base-TX performance
25MHz crystal or 3.3V/1.8V OSC input
Single 3.3V power input can be transformed to 1.8V via a low-cost external BJT transistor
Low power, 1.8/3.3V, 0.153?m CMOS technology
64-pin QFN ‘Green’ package
  
Applications  
HomePNA/HomePlug bridge solutions
Set-Top Box, TV, and VoIP applications
STM32芯片---上海银洋电子021-53086303
欢迎来电15900733302??采购找张经理
正点原子逻辑分析仪DL16劲爆上市
回复

使用道具 举报

26

主题

279

帖子

0

精华

中级会员

Rank: 3Rank: 3

积分
409
金钱
409
注册时间
2010-12-15
在线时间
0 小时
 楼主| 发表于 2012-2-21 14:23:46 | 显示全部楼层
还有一颗美信 立体声D类功放  MAX9702
STM32芯片---上海银洋电子021-53086303
欢迎来电15900733302??采购找张经理
回复 支持 反对

使用道具 举报

530

主题

11万

帖子

34

精华

管理员

Rank: 12Rank: 12Rank: 12

积分
165540
金钱
165540
注册时间
2010-12-1
在线时间
2117 小时
发表于 2012-2-21 16:32:09 | 显示全部楼层
SDRAM我倒是想用,不过st不支持SDRAM,有心无力啊...
我是开源电子网www.openedv.com站长,有关站务问题请与我联系。
正点原子STM32开发板购买店铺http://openedv.taobao.com
正点原子官方微信公众平台,点击这里关注“正点原子”
回复 支持 反对

使用道具 举报

26

主题

279

帖子

0

精华

中级会员

Rank: 3Rank: 3

积分
409
金钱
409
注册时间
2010-12-15
在线时间
0 小时
 楼主| 发表于 2012-9-4 09:40:48 | 显示全部楼层
hehe 
回复 支持 反对

使用道具 举报

26

主题

279

帖子

0

精华

中级会员

Rank: 3Rank: 3

积分
409
金钱
409
注册时间
2010-12-15
在线时间
0 小时
 楼主| 发表于 2012-9-12 10:58:05 | 显示全部楼层
.............
STM32芯片---上海银洋电子021-53086303
欢迎来电15900733302??采购找张经理
回复 支持 反对

使用道具 举报

26

主题

279

帖子

0

精华

中级会员

Rank: 3Rank: 3

积分
409
金钱
409
注册时间
2010-12-15
在线时间
0 小时
 楼主| 发表于 2013-1-29 13:14:01 | 显示全部楼层
kan kna
STM32芯片---上海银洋电子021-53086303
欢迎来电15900733302??采购找张经理
回复 支持 反对

使用道具 举报

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则



关闭

原子哥极力推荐上一条 /2 下一条

正点原子公众号

QQ|手机版|OpenEdv-开源电子网 ( 粤ICP备12000418号-1 )

GMT+8, 2025-7-22 02:04

Powered by OpenEdv-开源电子网

© 2001-2030 OpenEdv-开源电子网

快速回复 返回顶部 返回列表