我尝试把原子四轴遥控器的代码改成UCOS3系统出问题了求帮助

Zapateado · 发表于 2017-10-15 11:30:26

如题能过编译但是不能下载
报错信息如下。。。看不懂是说Erase Failed无法擦除么求帮助附上代码

Build target 'Target 1'
After Build - User command #1: E:\Keil_v5\ARM\ARMCC\bin\fromelf.exe --bin -o ..\OBJ\MALLOC.bin ..\OBJ\MALLOC.axf
"..\OBJ\MALLOC.axf" - 0 Error(s), 0 Warning(s).
Build Time Elapsed:  00:00:01
Load "..\\OBJ\\MALLOC.axf"
Set JLink Project File to "C:\Users\Napoleon\Desktop\UCOS3 Remoter\firmware\USER\JLinkSettings.ini"
* JLink Info: Device "STM32F103ZE" selected.

JLink info:
------------
DLL: V5.12g, compiled May 27 2016 16:57:47
Firmware: J-Link ARM-OB STM32 compiled Aug 22 2012 19:52:04
Hardware: V7.00
S/N : 20090928
Feature(s) : RDI,FlashDL,FlashBP,JFlash,GDBFull

* JLink Info: Found SWD-DP with ID 0x1BA01477
* JLink Info: Found SWD-DP with ID 0x1BA01477
* JLink Info: Found Cortex-M3 r1p1, Little endian.
* JLink Info: FPUnit: 6 code (BP) slots and 2 literal slots
* JLink Info: CoreSight components:
* JLink Info: ROMTbl 0 @ E00FF000
* JLink Info: ROMTbl 0 [0]: FFF0F000, CID: B105E00D, PID: 001BB000 SCS
* JLink Info: ROMTbl 0 [1]: FFF02000, CID: B105E00D, PID: 001BB002 DWT
* JLink Info: ROMTbl 0 [2]: FFF03000, CID: B105E00D, PID: 000BB003 FPB
* JLink Info: ROMTbl 0 [3]: FFF01000, CID: B105E00D, PID: 001BB001 ITM
* JLink Info: ROMTbl 0 [4]: FFF41000, CID: B105900D, PID: 001BB923 TPIU-Lite
ROMTableAddr = 0xE00FF000

Target info:
------------
Device: STM32F103ZE
VTarget = 3.300V
State of Pins:
TCK: 0, TDI: 0, TDO: 1, TMS: 0, TRES: 1, TRST: 1
Hardware-Breakpoints: 6
Software-Breakpoints: 8192
Watchpoints:       4
JTAG speed: 4000 kHz

Erase Failed!
Error: Flash Download failed  -  "Cortex-M3"
Flash Load finished at 11:24:37