我仿照原子哥原理图，做了个系统版下不进程序，求指导

小飞哥

 这是MDK上的错误           

**JLink Warning: No matching core found.
* JLink Info: SYSRESETREQ has confused core. Trying to reconnect and use VECTRESET.
**JLink Warning: Failed to reset CPU. VECTRESET has confused core.
* JLink Info: CPU core locked up
* JLink Info: CPU halted
* JLink Info: Core is locked-up, trying to disable WDT.
* JLink Info: CPU core locked up
* JLink Info: CPU halted
* JLink Info: Core is locked-up, trying to disable WDT.
* JLink Info: CPU core locked up
* JLink Info: CPU halted
* JLink Info: CPU core locked up
* JLink Info: CPU halted
**JLink Warning: S_RESET_ST not cleared
* JLink Info: SYSRESETREQ has confused core. Trying to reconnect and use VECTRESET.
**JLink Warning: Failed to reset CPU. VECTRESET has confused core.
* JLink Info: CPU core locked up
* JLink Info: CPU halted
* JLink Info: Core is locked-up, trying to disable WDT.
* JLink Info: CPU core locked up
* JLink Info: CPU halted
* JLink Info: Core is locked-up, trying to disable WDT.
* JLink Info: CPU core locked up
* JLink Info: CPU halted
* JLink Info: CPU core locked up
* JLink Info: CPU halted
**JLink Warning: S_RESET_ST not cleared
***JLink Error: Parity error (Data = 0xFFFFFFFF, ReceivedParity = 1)
***JLink Error: Could not start CPU core. (ErrorCode: -1)
硬件检查了许多次，感觉没问题，请问大神这个问题该怎样解决，是不是晶振的问题啊

 

miaoguoqiang

不要晶振也能下载程序的

745021926

No matching core found  是不是芯片型号不对？再检查硬件，测测JTAG的引脚

古月

肯定有问题。

小飞哥

买的芯片与mini板子上的一样都是stm32f103RBT6，j—link也测了高低电平与mini板j-link相同

小飞哥

原因应经找到，当我把芯片拔下，显示的是相同的信息，，这只有两种解释：一，芯片归西了，二，芯片虚焊了。这是我才买的芯片，从通电到结束芯片没发过一次热，芯片归西的可能性很小，当我拿烙铁再焊焊时，抱着试试看的心情下载了LED跑马灯程序，发现突然能下进去了，一切正常，事实说明芯片虚焊，经历与大家分享一下，希望大家引以为戒