定时器主从模式使用问题

zhoulushun

  定时器3设置成边沿捕获并且设置成主从模式
        TIM_SelectOutputTrigger(TIM3, TIM_TRGOSource_OC1);
        TIM_SelectMasterSlaveMode(TIM3, TIM_MasterSlaveMode_Enable);   
定时器4设置成输入捕获并且设置成从模式
//3õê¼»ˉTIM4êäèë2¶»ñ2Îêy
  TIM4_ICInitStructure.TIM_Channel = TIM_Channel_1; //CC1S=01         Ñ¡Ôñêäèë¶Ë IC1ó3éäμ½TI1éÏ
  TIM4_ICInitStructure.TIM_ICPolarity = TIM_ICPolarity_BothEdge;        //éÏéyÑØ2¶»ñ
  TIM4_ICInitStructure.TIM_ICSelection = TIM_ICSelection_TRC; //ó3éäμ½TI1éÏ  //TIM_ICSelection_DirectTI
  TIM4_ICInitStructure.TIM_ICPrescaler = TIM_ICPSC_DIV1;         //ÅäÖÃêäèë·ÖÆμ,2»·ÖÆμ
  TIM4_ICInitStructure.TIM_ICFilter = 0x00;//IC1F=0000 ÅäÖÃêäèëÂË2¨Æ÷ 2»ÂË2¨
  TIM_ICInit(TIM4, &TIM4_ICInitStructure);
       
  TIM_SelectInputTrigger(TIM4, TIM_TS_ITR2);
  TIM_SelectSlaveMode(TIM4, TIM_SlaveMode_Trigger);            
       
  TIM_ITConfig(TIM4,TIM_IT_Update|TIM_IT_CC1,ENABLE);//ÔêDí¸üDÂÖD¶Ï ,ÔêDíCC1IE2¶»ñÖD¶Ï        (¶¨ê±Æ÷òç3ö¸üDÂÖD¶Ï￡»2¶»ñÖD¶Ï)
  TIM_Cmd(TIM4,ENABLE );         //ê1Äü¶¨ê±Æ÷4


我现在想做的是用TIM3的TI1F_ED信号作为TIM4的输入捕获信号。这个配置的现象是当TIM3有上升沿时才会触发一次TIM4的捕获，而TIM3的下降沿不能触发TIM4的捕获，TIM3的捕获是正常的。求大神解答一下

qiyang1993

楼主成功了没